Re: Gauging Interest - Reproducing License Plate Bracket
I would need to make at least 10 of these to justify the effort to make the mold tooling.
Sent from my iPhone using ZR-1 Net Registry |
Re: Gauging Interest - Reproducing License Plate Bracket
Sign me up for one!
|
Re: Gauging Interest - Reproducing License Plate Bracket
I'd be surprised if you'd struggle getting rid of 10 pieces. Everywhere I've requested these, I've been told they are in high demand these days, and very hard to come by. I stille haven't found a single one.
|
Re: Gauging Interest - Reproducing License Plate Bracket
OK guys
I will proceed with the project It’ll be a few weeks to produce the molds. It takes two of them. Sent from my iPhone using ZR-1 Net Registry |
Re: Gauging Interest - Reproducing License Plate Bracket
This is the rear plate I requested earlier? If so, I'm in for one.
|
All times are GMT -4. The time now is 02:22 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020