Underhood and suspension cleanup
 

Hi everyone. 1994 124 was a Texas car and lived in a dusty environment. Once it was back up to spec mechanically it was time to give her a good bath.

There were two complications: First, the dust had some clay content and turned to a sticky paste when wet. Second, a "pro" detailer gave the inner fenders and wheel liners a coat of aerosol plasti-dip. The rubber coating encapsulated the dust and had to be removed with acetone, followed by cleaning the dirt itself.

Detailing tools were a spray bottle of distilled water, a spray bottle of Super Clean degreaser diluted 4:1, acetone, soft body and wheel brushes, a boar's-bristle brush, assorted small plastic and wire bristle brushes, microfiber cloths, and a Scotchbrite pad.

Re: Underhood and suspension cleanup
 

Our engine is showing its age and miles. It will never be truly beautiful again short of a refinish but its appearance can be improved. I used a mild polishing compound to remove surface contaminants and tried toothpaste and an Adams product as recommended here, but I wasn't able to clean deep stains.

In the pic below, the rear runners and cam cover directly beneath have been cleaned.


http://www.photoberkit.com/copper/al...l_IMG_4544.JPG

Re: Underhood and suspension cleanup
 

Here's a look at the rubber spray coating after a couple of thousand miles to Bowling Green for the Gathering.


http://www.photoberkit.com/copper/al...l_IMG_5135.JPG

Re: Underhood and suspension cleanup
 

Progress. Clean side on the right, dirty side on the left.


http://www.photoberkit.com/copper/al...l_IMG_5141.JPG

Re: Underhood and suspension cleanup
 

A closer before view of the inner fender and steering knuckle area.


http://www.photoberkit.com/copper/al...l_IMG_5179.JPG


http://www.photoberkit.com/copper/al...l_IMG_5180.JPG

Re: Underhood and suspension cleanup
 

This is more like it.


http://www.photoberkit.com/copper/al...l_IMG_5201.JPG

http://www.photoberkit.com/copper/al...l_IMG_5202.JPG

http://www.photoberkit.com/copper/al...l_IMG_5231.JPG

http://www.photoberkit.com/copper/al...l_IMG_5236.JPG

Re: Underhood and suspension cleanup
 

The engine area is looking much better in these after pics.


http://www.photoberkit.com/copper/al...l_IMG_5237.JPG

http://www.photoberkit.com/copper/al...l_IMG_5239.JPG

http://www.photoberkit.com/copper/al...l_IMG_5240.JPG

http://www.photoberkit.com/copper/al...l_IMG_5241.JPG

Re: Underhood and suspension cleanup
 

Here's the starting point for our rear suspension. Nasty.


http://www.photoberkit.com/copper/al...l_IMG_5253.JPG

Re: Underhood and suspension cleanup
 

Finished this side after dark and had to put a shop light on the subject to get a pic.


http://www.photoberkit.com/copper/al...l_IMG_5273.JPG

http://www.photoberkit.com/copper/al...l_IMG_5275.JPG

Re: Underhood and suspension cleanup
 

Here's the finished DS.


http://www.photoberkit.com/copper/al...l_IMG_5287.JPG

http://www.photoberkit.com/copper/al...l_IMG_5283.JPG