How deep to install pilot bearing?
 

My plan was to measure existing but the bronze bushing sspun in the bore and just fell out. Soooo, I see probably where it goes as the inner bore in the crank is stepped. Thought I would double check. I have the FSM but don't believe it is called out there. Thanks!

Update: 10-5-2016: Drive it in until it hits the shoulder. That puts it at about where Racinfan83 states below.

Re: How deep to install pilot bearing?
 

14.5 mm +/- .5 mm Mine went in to 14.9 and seemed to stop there.