Low level LCD Display 90s
In the latest HOB Marc has a write up about adding a 22k Ohm resister to help low lighting on the 90's .
Can a 91 set-up be used in replacement of the 90 to resolve this? |
Re: Low level LCD Display 90s
Quote:
|
Re: Low level LCD Display 90s
Did you do everything or only the gauges button and DIC section? as this this the section with the light sensor.
|
Re: Low level LCD Display 90s
Quote:
|
Re: Low level LCD Display 90s
Jeff I think your miss-understanding what I'm asking. HOB issue -64 page 35 Marc H has a write up on adding a 22k Ohm resistor to increase the low level display lighting on the 90. In the 91 this issue was fixed. I just wondered if the section that has the switches and DIC could be interchanged 90 to a 91? to resolve the low level lighting vs soldering in a resistor?
|
Re: Low level LCD Display 90s
90 and 91 switches are the same, circuits are the same. The change is in the CCM form the OEM standpoint. The resistor changes the voltage to act like the later years. So using a 91 switch assembly in the 90 will make no difference. Either way you need the resistor mod, in the case
|
Re: Low level LCD Display 90s
Jeff,
Have u been able to switch LED display contrast to white on black? |
Re: Low level LCD Display 90s
Thanks Jeff.
|
Re: Low level LCD Display 90s
Quote:
|
Re: Low level LCD Display 90s
Center. Speedo/Fuel
|
All times are GMT -4. The time now is 11:21 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020