What all to remove on the throttle body for powder coat?
Does the entire TB need to be bare for powder coat? Seems pretty delicate. Is there a how to? I searched for solutions. What all comes off? Any tips?
Thanks Sent from my iPhone using ZR-1 Net Registry |
Re: What all to remove on the throttle body for powder coat?
I strip them all the way down.
There is a nylon bushing under the primary return spring that can’t take the heat. Be sure to Dremel off the spot welds on the end of screws that retain the throttle blades to the shaft so you don’t wipe out the threads. Sent from my iPhone using ZR-1 Net Registry |
Re: What all to remove on the throttle body for powder coat?
4 Attachment(s)
Attachment 11602
Blade screw ends grown down. Attachment 11603 Nylon bushing Attachment 11604 Good time to replace the secondary stop screw with a hex head to make it easier to adjust Attachment 11605 Bare TB Sent from my iPhone using ZR-1 Net Registry |
Re: What all to remove on the throttle body for powder coat?
Quote:
|
Re: What all to remove on the throttle body for powder coat?
I am down to removing the blades - I can reach the rear of the blade screws in the two large ports, what about the small port on the bottom, is that supposed to be dremeled too? I don't have an attachment that will reach into the small port for the small blade.
|
Re: What all to remove on the throttle body for powder coat?
Remove the stop pin inserted into the primary throttle shaft which will allow you to flip the small blade over and get at the screw ends from the front side.
Sent from my iPhone using ZR-1 Net Registry |
Re: What all to remove on the throttle body for powder coat?
Quote:
I’ve been expecting them Robert. Sent from my iPhone using ZR-1 Net Registry |
Re: What all to remove on the throttle body for powder coat?
Agree with Phil. Full disassembly before powder coating..
Sent from my SM-G950U using ZR-1 Net Registry mobile app |
Re: What all to remove on the throttle body for powder coat?
1 Attachment(s)
|
Re: What all to remove on the throttle body for powder coat?
Damn Steve thats Georgous!
|
All times are GMT -4. The time now is 07:45 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020