Forum: C4 ZR-1 General Postings
6 Days Ago
|
Replies: 14
Views: 776
|
Forum: C4 ZR-1 Technical Postings
6 Days Ago
|
Replies: 39
Views: 1,370
Re: Code 61 with secondary system removed?
I believe u are way ?overthinking? this. If ur objective is to keep the secondaries open in all conditions except idle and decel, then what was sent is what is working for many users. U will likely...
|
Forum: C4 ZR-1 Technical Postings
6 Days Ago
|
Replies: 39
Views: 1,370
Re: Code 61 with secondary system removed?
Here's the conversion formula in the .xdf I have w the values calc'd from a stock $F0 BKKR bin. That's the conversion formula in the .xdf I sent you Brian.
The 10 and 104 value are what Haibeck uses...
|
Forum: C4 ZR-1 Technical Postings
1 Week Ago
|
Replies: 39
Views: 1,370
Re: Code 61 with secondary system removed?
Todd,
I?ve not seen anything in the calibration to allow for two injectors ON in idle conditions. My sense is that altho the PW is halved between the two injectors,
Idle would require a PW that...
|
Forum: C4 ZR-1 Technical Postings
1 Week Ago
|
Replies: 39
Views: 1,370
Re: Code 61 with secondary system removed?
You are giving the ECM conditions that it will virtually never see for it to close the secondaries. This also assumes u have the calibration set for FULL POWER always being ON. Finally I have my...
|
Forum: C4 ZR-1 General Postings
1 Week Ago
|
Replies: 14
Views: 776
Re: Aftermarket Head Unit Question
IIRC, I ran the wire down the left side under the door sill coverup into the hatch area where I did drill a small hole that gave me access to the area under the rear bumper cover. I made a small...
|
Forum: C4 ZR-1 Technical Postings
1 Week Ago
|
Replies: 39
Views: 1,370
|
Forum: C4 ZR-1 Technical Postings
1 Week Ago
|
Replies: 39
Views: 1,370
|
Forum: C4 ZR-1 General Postings
1 Week Ago
|
Replies: 14
Views: 776
Re: Aftermarket Head Unit Question
I installed a Pioneer AppRadio4 several years ago.No issue w fitting into stock radio opening. I love the iOS connectivity and added backup camera.
|
Forum: C4 ZR-1 Technical Postings
4 Weeks Ago
|
Replies: 8
Views: 928
Re: High idle
I had that issue some years ago. My TB is bored to 63mm. I ended up buying Marc?s ?helper spring?. After all these years the return spring loses some of its closing power. Haven?t had that issue...
|
Forum: C4 ZR-1 Technical Postings
4 Weeks Ago
|
Replies: 6
Views: 619
Re: Racetronix Injectors - any good?
Whichever injectors u select, I would highly recommend having them flow tested and then match the pairs. That made a significant difference for me in terms of idle, cruising smoothness, and mpg after...
|
Forum: C4 ZR-1 Technical Postings
4 Weeks Ago
|
Replies: 4
Views: 515
|
Forum: C4 ZR-1 Technical Postings
05-07-2024
|
Replies: 11
Views: 1,864
|
Forum: C4 ZR-1 Technical Postings
05-07-2024
|
Replies: 11
Views: 1,864
|
Forum: C4 ZR-1 Technical Postings
05-01-2024
|
Replies: 18
Views: 3,375
|
Forum: C4 ZR-1 Technical Postings
04-29-2024
|
Replies: 18
Views: 3,375
|
Forum: C4 ZR-1 General Postings
04-28-2024
|
Replies: 6
Views: 1,622
Re: Dyno rip of 1994 #15
Graham,
Was it the puffs of smoke that gave it away for knock? My experience is that if there is detonation it likely occurs between 4500-5500rpm on a WOT pull.
|
Forum: C4 ZR-1s and ZR-1 Parts For Sale/Wanted
04-26-2024
|
Replies: 8
Views: 2,349
|
Forum: C4 ZR-1 Technical Postings
04-16-2024
|
Replies: 3
Views: 919
|
Forum: C4 ZR-1 General Postings
04-10-2024
|
Replies: 185
Views: 66,646
Re: Best Sounding Exhaust for the ZR-1
I don?t recall exactly. Its either the 12288 or the 12198. Both are SS dual 2.5?outlet/3? center inlet. The 288 is 14in. length and the 198 is 18in. I believe I may have used the 288s.
|
Forum: C4 ZR-1 Technical Postings
04-07-2024
|
Replies: 17
Views: 1,721
Re: Solution for B&B Exhaust Drone?
What Karl is describing is what was done w the C6Z. In order to reduce weight, Corvette went w an Xpipe rather than a resonator, and to duplicate the effect of the resonator, they adopted a muffler...
|
Forum: C4 ZR-1 Technical Postings
04-06-2024
|
Replies: 17
Views: 1,721
Re: Solution for B&B Exhaust Drone?
Just a long term update. Last year the DynoMax muffs had pretty much become a boom chamber. We opened one up and the insulation was totally carbonized. This time I decided to go w MagnaFlow muff w...
|
Forum: C4 ZR-1 Technical Postings
04-04-2024
|
Replies: 22
Views: 2,327
Re: Continuing angst... headers today...
I realized that my P/S motor mount was broken after I kept seeing that the D/S exhaust tips would always end up slightly crooked after a ride. And it was no matter how tight I would make the exhaust...
|
Forum: C4 ZR-1 General Postings
03-27-2024
|
Replies: 185
Views: 66,646
Re: Best Sounding Exhaust for the ZR-1
I recently replaced my DynaMax Ultraflows w MagnaFlow mufflers. Both have the Z06 NPP valves installed on them similar to the B+B Fusion system. The Maggies produce a more mellow exhaust note at...
|
Forum: C4 ZR-1 Technical Postings
03-23-2024
|
Replies: 10
Views: 1,314
|