ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > Search Forums

Showing results 1 to 25 of 127
Search took 0.01 seconds.
Search: Posts Made By: onetinsoldier
Forum: C4 ZR-1 Technical Postings 01-16-2024
Replies: 14
Views: 1,540
Posted By onetinsoldier
Re: Horsepower difference ?

I believe you are correct, porting and some change in cam grinding , gave it the 30hp gain . I know chevrolet used to retard cam timing years ago for emissions and hp reduction to meet standards.
Forum: C4 ZR-1 Technical Postings 01-16-2024
Replies: 14
Views: 1,540
Posted By onetinsoldier
Horsepower difference ?

Heres a dumb question...........the first ZR1's had 375 hp , then it jumped to 400 hp, what change or addition made the difference in horsepower gain ?
Forum: C4 ZR-1 Technical Postings 04-07-2022
Replies: 11
Views: 1,162
Posted By onetinsoldier
Re: Stumbling Issue

Try the coolant temp sender , if its not working correctly , it wont send the correct reading to the ecm . And put a gm part back in ! some aftermarket parts just dont meet the grade !
Forum: C4 ZR-1 Technical Postings 04-09-2020
Replies: 2
Views: 661
Posted By onetinsoldier
Forum: C4 ZR-1 Technical Postings 04-02-2020
Replies: 2
Views: 661
Posted By onetinsoldier
Antenna wire question

I am trying to test my power antenna but cant find a wire schematic . The antenna is down . I need to know if I remove the connector from the antenna to the relay what wires do I need to put power to...
Forum: Corvette Audio/Electronics 12-24-2019
Replies: 9
Views: 8,499
Posted By onetinsoldier
Re: For sale: clean and tested amps

The fronts still available ? Thanks !
Forum: Southeast Region 12-05-2019
Replies: 9
Views: 1,973
Posted By onetinsoldier
Forum: C4 ZR-1 Technical Postings 12-05-2019
Replies: 5
Views: 606
Posted By onetinsoldier
Re: 1990 ZR1 Head Lights stuck on High Beams

Try changing from hi to low with the tilt in different positions , it could be the rod that goes to the switch or the switch under the dash on the column
Forum: C4 ZR-1 Technical Postings 12-05-2019
Replies: 9
Views: 819
Posted By onetinsoldier
Re: 1990 ZR1 Cruise Control

Check the brake light switch , some have vacuum lines ,that have an o-ring that goes bad . Its good to have a mighty-vac tool to check for leaks in vacuum lines .
Forum: C4 ZR-1 Technical Postings 11-26-2019
Replies: 137
Views: 10,441
Posted By onetinsoldier
Re: 93 Starter Not Engaging

The firewall on the drivers side inside the large wire loom, between the ecm and the engine. its either 10 or 12 ga wire
Forum: C4 ZR-1 Technical Postings 11-25-2019
Replies: 11
Views: 1,097
Posted By onetinsoldier
Re: Another No-Start Condition

Have you put a fuel pressure gauge on it to see if the rails have fuel ?
Forum: C4 ZR-1s and ZR-1 Parts For Sale/Wanted 11-22-2019
Replies: 1
Views: 303
Posted By onetinsoldier
WTB a good shifter knob

I need a good shifter knob ! Thanks
Forum: C4 ZR-1 Technical Postings 11-22-2019
Replies: 12
Views: 1,684
Posted By onetinsoldier
Re: No Hot Start , found the problem ....Solved !!!

Ok , after having a couple of days off to test some things ….. after a test drive , it would crank but wouldn't start as usual . So I decided to put my mechanical fuel pressure gauge on , a rag...
Forum: C4 ZR-1 Technical Postings 11-11-2019
Replies: 12
Views: 1,684
Posted By onetinsoldier
Re: No Hot Start , found the problem ....

Yes the security light blinks . If I spray carb cleaner in the plenum , it starts every time , so something is not getting the injectors to spray when the engine is hot and you park , then go back to...
Forum: C4 ZR-1 Technical Postings 11-10-2019
Replies: 12
Views: 1,684
Posted By onetinsoldier
Re: No Hot Start , found the problem ....

I have a gauge on the fuel rail and it has about 55 lbs. I thought if vats was causing it, it would not let the starter spin ? is it possible to stop the injectors from working and not the starter ?
Forum: C4 ZR-1 Technical Postings 11-09-2019
Replies: 12
Views: 1,684
Posted By onetinsoldier
No Hot Start , found the problem ....

Once again the "no hot start" issue is a no fuel issue ! I have fuel to the rails , good pressure , good spark , but something is causing the injectors not to fire when its hot . I spray carb cleaner...
Forum: C4 ZR-1 Technical Postings 10-28-2019
Replies: 1
Views: 436
Posted By onetinsoldier
Tap the gas to get it to start ?

Ok , after driving and parking and the engine is hot , it cranks ,but won't start ….. I recently found out that if I tap the pedal , it starts . Now when its cold, I don't tap the pedal, there's...
Forum: C4 ZR-1 Technical Postings 10-27-2019
Replies: 2
Views: 381
Posted By onetinsoldier
Starter Heat wrap ?

Good idea or bad to use heat wrap on the starter ? In one way it could reflect heat , the other being that its in an enclosed area it could cause it not to dissipate heat and cause failure . Any...
Forum: C4 ZR-1 Technical Postings 09-29-2019
Replies: 1
Views: 438
Posted By onetinsoldier
Body part question !

Ok does anyone know the name or part number for the square sheet metal tube that is in the underside of the nose of the hood ? It is what the headlight frames bolt to with about a 2in screw . They...
Forum: C4 ZR-1 Technical Postings 09-27-2019
Replies: 6
Views: 642
Posted By onetinsoldier
Re: A/C compressor is screaming........

don't drive it , mine did that and before I got home I , it cut through the snout of the compressor and couldn't be repaired !
Forum: C4 ZR-1 Technical Postings 09-27-2019
Replies: 4
Views: 625
Posted By onetinsoldier
Re: Underhood paint

No I don't use any spray like armor-all or any other type of tire dressing on my cars , but thanks for the heads up ! When I used to paint cars , we kinda banned the stuff from the paint booth area ,...
Forum: C4 ZR-1 Technical Postings 09-26-2019
Replies: 4
Views: 625
Posted By onetinsoldier
Underhood paint

Is the underside of the hood a black satin or semi-flat black ? I had bought a gallon years ago from the local chevy dealer , and no longer have the can !
Forum: C4 ZR-1 Technical Postings 06-12-2019
Replies: 11
Views: 1,127
Posted By onetinsoldier
Re: Old battery = no hot start?

I have had the same problem , I was told it was the crank sensor , I replaced it twice and still have the same problem ! So I'm still looking for an answer !
Forum: Southeast Region 05-30-2019
Replies: 12
Views: 2,422
Posted By onetinsoldier
Re: Need windshield installed Tampa FL area

Did you try the vette shop on Dale Mabry ? Ask Mike or Jennifer , if they don't do it there , they may tell you who to contact .
Forum: C4 ZR-1 Technical Postings 10-22-2018
Replies: 2
Views: 485
Posted By onetinsoldier
Re: Master Cylinder ?

Thanks ! I picked one up at the parts warehouse in Tampa .
Showing results 1 to 25 of 127

 
Forum Jump

All times are GMT -4. The time now is 11:31 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020