Quote:
Originally Posted by GOLDCYLON
When the installer installed the new bands did they install them 180 degrees from the vlave stem? You will need to use a scanner/code reader or a paperclip on the ALDL port to clear the codes.
Look at post #4 for some clearing the codes ideas
http://www.zr1.net/forum/showthread....clearing+codes |
Thanks GOLDCYLON I used a code reader and tried to clear the falt code useing it as instructed but nothing has worked. That is when I pulled the fuse listed in the instructions that the repair manul said to remove. Yes I made sure they were installed 180 degrees out. I don't understand why I can't clear the falt code.