Quote:
Originally Posted by GOFAST
I have a '95 with about 9k miles. After a short burst at WOT (wide open throttle), the service engine soon comes on but then goes out after a few seconds. Any idea on the cause or how I can capture the code?
Thanks
|
Do you have the power key on? Try with it off.
If it does not happen with the key off that is a data point
for going forward.
Easiest way to get codes out is with a scanner ($80 or so).
It's a good investment. Most parts stores will have them.
There is a way to read them out on the dash that involves
shorting two pins on the diag connector the turning the ign key on.
This is tedious but
if you want to one of us can post the procedure.