Quote:
Originally Posted by Dynomite
The Starter Relay addition under the ECM is No Band Aid.....it is a Cure 
In Conjunction with the Starter Solenoid Refurbishment of the Points (and checking the overall condition of the starter at the same time including armature bearings on each end) 
I could just come up there Jeff and do it for you (fix your No Start Issue) 
The 15 Minute Starter Relay Installation under the ECM and the Starter Solenoid Refurbishing with the 10 Minute Plenum Removal.
We could also do the Injector Housing TB Coolant Blocking (You will not be able to tell it has been done from outside appearance when I am finished).
But then again I am not sure of the condition of your Injector Housing Coolant Manifolds (May need heat to remove the bolts) .
It is a 3 hr drive from here in CA and too hot anyway and Acetylene Torch will not fit in the ZR-1 (with Cylinders) 
I will leave it for Paul to help you and explain further....it is too complicated for me with all the diagrams 
Good Luck Guys 
|
Thank you Cliff for the offer,I just found the relay and will look for the wiring diagram you have in the solutions section.