ZR-1 Net Registry Forums - View Single Post

mike100 · 01-29-2018

I used 3" split pipe clamp on connections from the SW performance connect kit. The LS7 cats were slightly angled inboard from full length Watson headers to fit the tunnel. They would fit better on the short OBX headers, but They ran great and had no unburned hydrocarbon smell or any issues with burning the floorboards. I was able to fit them withing the confines of the factory heat shielding (if just barely).

I lost all the photobucket pics- give me time to redo that.

01-29-2018	#7
mike100 Join Date: Feb 2011 Location: San Marcos CA Posts: 1,802	Re: Z06 Cats I used 3" split pipe clamp on connections from the SW performance connect kit. The LS7 cats were slightly angled inboard from full length Watson headers to fit the tunnel. They would fit better on the short OBX headers, but They ran great and had no unburned hydrocarbon smell or any issues with burning the floorboards. I was able to fit them withing the confines of the factory heat shielding (if just barely). I lost all the photobucket pics- give me time to redo that.