Re: Cam Position Sensor Removal
Quote:
Originally Posted by 32valvZ
Honestly, I wouldnt use anything to try to fix that crack... you wouldnt want RTV or any kind of epoxy floating around in the oil galleys and I doubt super glue would hold. Its now an official paper weight.  |
Yes but..... it?s not like I can just run to NAPA and replace it. It still works. The leak was minor. The oil pan gasket leaks much more. It seems a little super glue in the crack with a skim of high temp silicone would be worth a try. Epoxy may be an overkill and more risky. My guess the sensor itself is bedded in epoxy internally and should be fine even with a crack in the outer shell. The crack is barely visible.
__________________
1995 ZR1 #159
Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp
1992 ZR1 #280
Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp
1996 Collectors LT4 (Stock)
1972 Convertible 434 Small Block
572 rwhp
|