ZR-1 Net Registry Forums - View Single Post

1991 Corvette ZR-1 · 10-07-2022

Alright, if I remember an old diagram I found from Jerry posting on here I did this right. Inlet into the can is the hose connected to the pcv valves assembly at back of plenum. The outlet from the can is hose going to the pipe coming off the front of plenum just behind the throttle linkage. A few pics. I?ll take it for a test sometime today or tomorrow. I tried to keep this as clean an install as possible.

10-07-2022	#2
1991 Corvette ZR-1 Join Date: Sep 2018 Location: Florida Posts: 294	Re: Reluctantly joining the catch can club Alright, if I remember an old diagram I found from Jerry posting on here I did this right. Inlet into the can is the hose connected to the pcv valves assembly at back of plenum. The outlet from the can is hose going to the pipe coming off the front of plenum just behind the throttle linkage. A few pics. I?ll take it for a test sometime today or tomorrow. I tried to keep this as clean an install as possible. Last edited by 1991 Corvette ZR-1; 02-22-2024 at 10:04 PM.