Quote:
Originally Posted by Dynomite
Is that the same location of the Vacuum Pump Fuse for the 1990?
Thanks for the information......
|
Quote from Corvette Forum:
Quote:
Originally Posted by BiZ
Thanks for the suggestions. Problem solved. I got this email today:
"Not sure about a 91 but here's info. on a 90 and 95.
>
> On a 90 ZR1 the fuse is mounted on the driver side plastic
> fender well right below the end of the brake master cylinder.
>
> A 10amp fuse is located inside a small black plastic housing.
> The housing is a about 2 inches long and 1 inch wide.
> Going to the housing are two wires. Orange wire from the ignition
> switch which has 12 volts when the ignition switch is in start or run.
> There is a Dark Blue wire coming out of the housing that goes
> to the Vacuum Pump motor.
>
> On a 95 the Valet fuse which is fuse #17 (10amp) in the main fuse
> block on the side of the dash when you open the passenger side door.
> It provides 12 Volts to the Vacuum Pump when the ignition switch is in run or start. At the pump is a Brown wire. This is the wire that
> comes from the Valet fuse. If the Full Power LED is on, the Valet fuse is good."
Sure enough that fuse was toast.
|
It seems it is the same location '90-'91.
Let's hope the picture will be useful to somebody!