[tnova]

To install the driver's side injector housing I was removing the vent hose from the crankcase vent cover. The hose clamp was completely loose and when I put a rotation and pull motion on the hose, the tube came out of the vent cover instead of the hose separating from the hose. (The hoses are original and very hard. New ones on order from Jerry's)


The tube wasn't damaged. There was a sealant or adhesive around the tube portion that fits in to the cover. I've totally cleaned it up plus any that was in the bore on the cover.


Question: What sealant or adhesive should I use when I reseat the tube in the vent cover?


Tony - Tnova