ZR-1 Net Registry Forums - View Single Post

Marc Haibeck · 06-11-2017

If necessary replace the battery and turn the PKE off by holding the door button for over two seconds or until you hear the locks cycle as a confirmation that the command was received.

If the battery is at 3.0 volts or more it's okay.

The door switch should not have a hair trigger. The switch should be adjusted so that the door moves back about 1/16" before turning on the interior lights.

If the pin at the tip of the switch needs to extend out more, pull the pin out and shim it with washers.

06-11-2017	#11
Marc Haibeck Join Date: May 2007 Location: Addison IL Posts: 239	Re: Door Lock Actuators If necessary replace the battery and turn the PKE off by holding the door button for over two seconds or until you hear the locks cycle as a confirmation that the command was received. If the battery is at 3.0 volts or more it's okay. The door switch should not have a hair trigger. The switch should be adjusted so that the door moves back about 1/16" before turning on the interior lights. If the pin at the tip of the switch needs to extend out more, pull the pin out and shim it with washers.