[aafc]

Scott,
do search "starter enable relay".
then check out car would't start------------------what say the brotherhood.
go to post #19. he shows a relay to operate the starter.
What i did 1.find the purple wire in the large loom just behind the ECM.
it would be a 10 Ga. purple wire (the only one in their ). in the FSM you see
that c100 connection that is the bulkhead connector going into the car. I
tapped into the wire just behind the ECM.
2. tap into the purple wire (i did not cut mine) run that wire to a relay mounted
just above the battery (swing contact) other end to a inline fuse then to the
battery. connect your normally open moment switch ( I used a flip up covered
toggle switch) this switch would send 12v directly to the starter solenoid and
operate the starter. You could mount the switch near the relay or install it
were you could get to it fairly easy in side your car.

now for the starter enable relay. look at the starter enable relay. pull the relay out and open the cover, then solder a wire across the relay contacts.
replace cover install relay. (this makes the relay always closed).
Someone posted that you should run a wire from ground to the black with
yellow trace on #2 of the starter enable relay. that wire goes to the
Central control module ( CCM ).
Hope this helps
John