Quote:
Originally Posted by Vette Guy
Todd,
I've been running a set for years - I purchased 1/4" phenolic sheet from NORVA Plastics when I lived close to them (they sell excess job material on eBay), and made my own using the gasket as a template. The material is very easy to work with and cut/shape/sand as needed. They are currently selling 1/4" sheets on eBay (G10).
Good Luck!
Regards,
Mark
|
G10 is not the same as phenolic. Phenolic is cotton, linen, or paper. G10 is fiberglass. It is more dense, and much harder on tooling. Just an FYI. I was a manufacturing engineer in a job shop where we sold and machined a lot of both.