ZR-1 Net Registry Forums - View Single Post

KJL · 03-20-2016

My plan was to measure existing but the bronze bushing sspun in the bore and just fell out. Soooo, I see probably where it goes as the inner bore in the crank is stepped. Thought I would double check. I have the FSM but don't believe it is called out there. Thanks!

Update: 10-5-2016: Drive it in until it hits the shoulder. That puts it at about where Racinfan83 states below.

03-20-2016	#1
KJL Join Date: Mar 2013 Location: Roswell, GA Posts: 232	How deep to install pilot bearing? My plan was to measure existing but the bronze bushing sspun in the bore and just fell out. Soooo, I see probably where it goes as the inner bore in the crank is stepped. Thought I would double check. I have the FSM but don't believe it is called out there. Thanks! Update: 10-5-2016: Drive it in until it hits the shoulder. That puts it at about where Racinfan83 states below. __________________ 1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp Last edited by KJL; 10-05-2016 at 09:47 PM.