Re: porting injector housings to 36MM
Quote:
Originally Posted by tpepmeie
The oversize inlet valves back then were typically 1.600" inches / 40.6mm.
|
I have to correct my post above after talking to Bill. The correct measurements for the valves he installed are: intake 1.580" or 40.132mm and exhaust are 1.445" or 36.703mm.
Perhaps Kurt had additional machining done and new valves after Bill did the initial work?
__________________
Todd
____________________________________
*** our email address has changed!
info@pepmeierengines.com
pepmeierengines.com
Friend us on Facebook too: www.facebook.com/profile.php?id=100011443683384
Pepmeier Engine Development
Last edited by tpepmeie; 03-16-2021 at 01:09 PM.
|