ZR-1 Net Registry Forums - View Single Post

KJL · 12-01-2020

Update:
Repaired the crack with JB weld for plastic. Used a Dremel to plow a small groove along the crack to give it more bite and roughed up with 180 sand paper. Use silicone around the o-ring seal as well. Did not install until everything had cured. So far no leak. Need more heat cycles to be sure but why not try.

12-01-2020	#14
KJL Join Date: Mar 2013 Location: Roswell, GA Posts: 232	Re: Cam Position Sensor Removal Update: Repaired the crack with JB weld for plastic. Used a Dremel to plow a small groove along the crack to give it more bite and roughed up with 180 sand paper. Use silicone around the o-ring seal as well. Did not install until everything had cured. So far no leak. Need more heat cycles to be sure but why not try. __________________ 1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp Last edited by KJL; 12-01-2020 at 09:55 PM.