Re: Cam Position Sensor Removal
Quote:
Originally Posted by KJL
Update: Sensor is cracked. Starts on top and travels down the side. I think it stops just short of the seal. There is mold seam there as well which makes it harder to verify where the crack stops and the seam starts. I need to get a closer look with a jewelers loupe.
As luck would have it I ordered a new one from Phil but if I can, I would like to try and repair the crack if possible. The sensor still works. Any thoughts? Super glue? Epoxy? RTV? How much clearance between the sensor and the cam?
Only a little oil cam out when I removed it.
|
Honestly, I wouldnt use anything to try to fix that crack... you wouldnt want RTV or any kind of epoxy floating around in the oil galleys and I doubt super glue would hold. Its now an official paper weight. 
__________________
[B]1990 #2815[/B]
[COLOR="Red"][B]Red/Red[/B][/COLOR]
Ported Plenum & IH (by Pete)
Haibeck Chip
Rebuilt FPR (by Phil)
FIC Injectors
Watson LT Headers
3" Stainless Works exhaust
Lingenfelter Open Air Lid
Bill B Built Transmission
Shifter & C Beam Plates
[FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT]
[FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT]
[B]SOLD[/B]
|