Searching for a Fuel Line Clip

[dzim]

I am looking for a discontinued GM part number 10052168. It is a small retainer clip (bracket) for the fuel lines on a 1994 ZR-1 Corvette. The part sits just above the blower motor control module just forward of the firewall on the passenger side. It appears to be unique for the ZR-1 model as I have not seen it on the 1994 Corvette with the LT1 engine.

Thanks,
Dale Zimmerman
1994 Black Rose ZR-1
Lincoln, Nebraska

[scottfab]

ask on this thread. I bet it's the same part on a 90.
http://zr1.net/forum/showthread.php?t=21073

[ZZZZZR1]

Originally Posted by dzim

I am looking for a discontinued GM part number 10052168. It is a small retainer clip (bracket) for the fuel lines on a 1994 ZR-1 Corvette. The part sits just above the blower motor control module just forward of the firewall on the passenger side. It appears to be unique for the ZR-1 model as I have not seen it on the 1994 Corvette with the LT1 engine.

Thanks,
Dale Zimmerman
1994 Black Rose ZR-1
Lincoln, Nebraska

Dale

Can you take a picture of what you need?

Sent you a link to Kurt's site. He has the part #



David

[Blue Flame Restorations]

It's the same black plastic part used on the fuel lines underneath the car in two places.

[dzim]

David,
There is not much left of the clip on my car. Not sure a picture would do any good. Who knows how long the clip has been broken. However, it is there for a reason. When the fuel lines are not retained by this clip, they are free to vibrate. One of them actually rubbed through the insulation on the lead wire to the blower motor. That in turn blew a fuse. I have a temporary fix that uses two black zip ties to hold the fuel lines in place, but would like to find the correct clip if anyone has one?

Thanks,
Dale

[dzim]

Thanks for the information, Dynomite. Exactly what I need!!

Carter, if you are out there, what is the status on making this Fuel Line Bracket out of Billet Aluminum?

Thanks,
Dale Zimmerman

[carter200]

Dale,
I sent you an email before seeing your distress message. I'll be making the fuel line block starting tomorrow. I had to catch-up on earlier commitment jobs and had an unscheduled downtime on the CNC.
Dynomite and Fully Vetted provided me with the samples I needed to get my specs. Sorry you had an issue with the blown fuse. Take care, Carter

PS: I have a list started of who wanted/needed the item just need to find it. If you remember contacting me about needing one please speak up here and I'll for sure have you down for one. No price yet but it's not gonna break the bank and shipping in the US will be included.

Thanks to all who support CT Machining. You are appreciated!!!

[carter200]

Cliff,
I will certainly post a pic and price when done. I have not forgotten that you wanted a billet oil dipstick handle, too. Let the blinging begin

[carter200]

I found the list I started. The following stated they wanted one:

David Adams
Dynomite (2)
=Jeff=
Jim Zorgias
1991ZR1
Dale Zimmerman
HawaiiZR-1
GCylon
Ted Feder
Whale (2)


Just give me heads-up and I'll add you to the list if you want one.....

[carter200]

Originally Posted by Dynomite

Let me see what you come up with......may want two. Can you etch in red anything on the ends?

Cliff,
I do not "etch". I engrave . There is not a whole bunch of room to put more than a few characters and the color is up to the customer. I thought you wanted 2 anyways cause of the octane ratings?