no start at times

[aafc]

Well i have been having a no start at times with my auto eq ZR-1. Last week at the track ( drag) first run ok next run the scoreboard fail and i had to wait for about 20 mins while they installed a new chip. Ok time to fire up guess what
no start. It was too loud to hear anything so i was pushed back. After a
couple more tries it fired up. So i just went home to play it safe.
Sunday removed starter, Monday it went to a repair shop to be rebuilt. Got
the starter back about 4:30 p.m. Monday. Installed starter while i was in there
i tapped into the black with yellow tracer to gr from the starter enable relay
as posted in a post from Gorden K. Good right? Wrong it failed again while
i was at coastal corvettes the following Monday. I could only hear the starter
click but no turn over. So i used a wire from the Battery to the large purple
wire going to the starter, turned key on with car in park (auto ) it started
right up when i touched the Battery feed to the purple wire.
Well i went and replaced the starter enable relay as a precaution. As long
as i have the drivers side hush panel down i would run a wire from a no/mon
toggle switch next to my B&M shiftier to a relay that would feed 12v to the
starter went i operate the toggle switch. So now if car won't start i can
leave the key in the on position and start the car with the toggle switch.
I have removed the clutch relay and ran the wires (yellow and purple) to
safety switch on the auto shiftier so car will only start when it is park or
neutral position.
I'am going racing this Fri. night to test & tune and to see if just replacing
the starter enable relay has helped.
thanks for the help
John
1990 white/black #2546
one of a few auto (4l80E ) EQ. ZR-1's
member 0115