porting injector housings to 36MM

[tpepmeie]

Originally Posted by wfot

I got the heads already ported, I believe they were actually done by bill krichoffner for kurt white's old 415 from way back, the valves are 41.5mm and 35.5mm stainless. the chambers have had some smoothing/unshrouding done, but I think they could use a little more. Ti retainers/secondaries removed.

I understand that the stage III's have a pretty high peak RPM, so I am expecting peak between 6900 and 7350 or so..

The oversize inlet valves back then were typically 1.600" inches / 40.6mm.
Bill is a great guy, I just talked to him a few weeks ago.

This is a 402" engine? 4.00" stroke?

compression? << nevermind, I see 12:1>>>

[tpepmeie]

Originally Posted by tpepmeie

The oversize inlet valves back then were typically 1.600" inches / 40.6mm.

I have to correct my post above after talking to Bill. The correct measurements for the valves he installed are: intake 1.580" or 40.132mm and exhaust are 1.445" or 36.703mm.

Perhaps Kurt had additional machining done and new valves after Bill did the initial work?