ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > Corvette > Corvette Technical Questions

Reply
 
Thread Tools Display Modes
Old 03-20-2016   #1
KJL
 
Join Date: Mar 2013
Location: Roswell, GA
Posts: 232
Default How deep to install pilot bearing?

My plan was to measure existing but the bronze bushing sspun in the bore and just fell out. Soooo, I see probably where it goes as the inner bore in the crank is stepped. Thought I would double check. I have the FSM but don't believe it is called out there. Thanks!

Update: 10-5-2016: Drive it in until it hits the shoulder. That puts it at about where Racinfan83 states below.
__________________
1995 ZR1 #159
Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp
1992 ZR1 #280
Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp
1996 Collectors LT4 (Stock)
1972 Convertible 434 Small Block
572 rwhp

Last edited by KJL; 10-05-2016 at 09:47 PM.
KJL is offline   Reply With Quote
Old 04-20-2016   #2
Racinfan83
 
Join Date: Apr 2013
Location: Eastern Missouri
Posts: 773
Default Re: How deep to install pilot bearing?

14.5 mm +/- .5 mm Mine went in to 14.9 and seemed to stop there.
__________________
[LEFT][SIGPIC][/SIGPIC][/LEFT]
[CENTER][COLOR=Indigo][SIZE=4][I][B] **Now Sold** 1990 ZR-1 #2093, Black on Black..[/B][/I][/SIZE][/COLOR][/CENTER]
Racinfan83 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:38 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020