Put it on a rack... concerning tire wear - ZR-1 Net Registry Forums

Regimof · 07-02-2016

I have a friend that has a shop and I convinced him to let me put the Z on so I could clean up underneath and see what's what. I've had it on a couple drives and figure that the cobwebs should be shaken out and any new issues might present themselves.

So after we looked online for 25 minutes on how to get a c4 up correctly, we lifted it and the first thing we saw was the rear tires are toast. That happens. It's due anyway. The concerning part, for me, is how they wore. The insides on both tires were considerably more worn..one actually has wires showing... and the outsides are fine.

Is this something I should be worried over? It doesn't seem right, but I not a smart man. I'm not familiar with these fat tires.

One more thing... occasionally when I get on it, that brake warning light comes on. Like I have the parking brake on. Nothing happens.. just the light. Thoughts?

BigJohn · 07-02-2016

Quote:

Originally Posted by Regimof

I have a friend that has a shop and I convinced him to let me put the Z on so I could clean up underneath and see what's what. I've had it on a couple drives and figure that the cobwebs should be shaken out and any new issues might present themselves.

So after we looked online for 25 minutes on how to get a c4 up correctly, we lifted it and the first thing we saw was the rear tires are toast. That happens. It's due anyway. The concerning part, for me, is how they wore. The insides on both tires were considerably more worn..one actually has wires showing... and the outsides are fine.

Is this something I should be worried over? It doesn't seem right, but I not a smart man. I'm not familiar with these fat tires.

One more thing... occasionally when I get on it, that brake warning light comes on. Like I have the parking brake on. Nothing happens.. just the light. Thoughts?

When set up with racing camber, your tires will wear more on the inside like you described.

GOLDCYLON · 07-02-2016

Quote:

Originally Posted by Regimof

I have a friend that has a shop and I convinced him to let me put the Z on so I could clean up underneath and see what's what. I've had it on a couple drives and figure that the cobwebs should be shaken out and any new issues might present themselves.

So after we looked online for 25 minutes on how to get a c4 up correctly, we lifted it and the first thing we saw was the rear tires are toast. That happens. It's due anyway. The concerning part, for me, is how they wore. The insides on both tires were considerably more worn..one actually has wires showing... and the outsides are fine.

Is this something I should be worried over? It doesn't seem right, but I not a smart man. I'm not familiar with these fat tires.

One more thing... occasionally when I get on it, that brake warning light comes on. Like I have the parking brake on. Nothing happens.. just the light. Thoughts?

Check you brake fluid level at the master cylinder. As to inner tire wear make sure your car has a 4 wheel road force balancing and alignment. Toe or camber is off. That is not normal meaty tire or not. GC

Corvettes White · 07-02-2016

Look for worn bushings on the rods.

Regimof · 07-02-2016

Where does one acquire a 4 wheel force balancing

Regimof · 07-02-2016

I'm not sure if this helps, but it only had 24xxx miles on it

GOLDCYLON · 07-02-2016

Quote:

Originally Posted by Regimof

Where does one acquire a 4 wheel force balancing

You have to look around for shops that perform it and have the equipment. I'm a believer as I had to get mine all redone when I went to coil overs and it solves abnormal tire wear unless the car is set to a particular setup for autocross etc.

RussMcB · 07-02-2016

Sure sounds like way too much negative camber to me. Or not enough hard cornering. :-)

Our tires are so fat, proper camber is more important than for most cars.

07-02-2016	#1
Regimof Join Date: Jun 2016 Location: Prior lake Posts: 65	Put it on a rack... concerning tire wear I have a friend that has a shop and I convinced him to let me put the Z on so I could clean up underneath and see what's what. I've had it on a couple drives and figure that the cobwebs should be shaken out and any new issues might present themselves. So after we looked online for 25 minutes on how to get a c4 up correctly, we lifted it and the first thing we saw was the rear tires are toast. That happens. It's due anyway. The concerning part, for me, is how they wore. The insides on both tires were considerably more worn..one actually has wires showing... and the outsides are fine. Is this something I should be worried over? It doesn't seem right, but I not a smart man. I'm not familiar with these fat tires. One more thing... occasionally when I get on it, that brake warning light comes on. Like I have the parking brake on. Nothing happens.. just the light. Thoughts?

07-02-2016	#4
Corvettes White Join Date: Dec 2003 Posts: 467	Re: Put it on a rack... concerning tire wear Look for worn bushings on the rods.

07-02-2016	#5
Regimof Join Date: Jun 2016 Location: Prior lake Posts: 65	Re: Put it on a rack... concerning tire wear Where does one acquire a 4 wheel force balancing

07-02-2016	#6
Regimof Join Date: Jun 2016 Location: Prior lake Posts: 65	Re: Put it on a rack... concerning tire wear I'm not sure if this helps, but it only had 24xxx miles on it

07-02-2016	#8
RussMcB Join Date: Jan 2015 Location: Marietta, GA USA Posts: 1,160	Re: Put it on a rack... concerning tire wear Sure sounds like way too much negative camber to me. Or not enough hard cornering. :-) Our tires are so fat, proper camber is more important than for most cars. __________________ Russ McBride, [COLOR="Red"]Car Sold 8/2020[/COLOR] #1635, Marietta, GA USA, 1991 ZR-1, #766 (bought 1/1/2015) MS3-Pro, OBX, SW X-Pipe, Borla, Hurst, SLP, Goodyear F1 GS-D3, Kenwood. HOTB 2016Q3 [IMG]http://zr1.net/forum/picture.php?albumid=316&pictureid=2873[/IMG] [IMG]http://zr1.net/forum/picture.php?albumid=336&pictureid=2985[/IMG] Last edited by RussMcB; 07-02-2016 at 10:27 PM.