|
05-31-2020
|
#1 |
 
Join Date: Oct 2016
Location: Shepparton. Vic. Australia
Posts: 135
|
Rear ride height question.
To lower the rear end , there are longer bolts available through various vendors. Ok, well l noticed while the z was up on the hoist yesterday that there is approx 1 inch of useable thread left below the split pin currently. Would re-drilling split pin hole and winding down the nut to the bottom of the bolt achieve any noticeable difference. If so approx how much? Would it be by the amount the nut was wound down? Apologies if this is a dumb question, but if you don’t ask you’ll never know.
|
|
|
|
05-31-2020
|
#2 |
Join Date: Dec 2007
Location: Fremont,Ca
Posts: 3,038
|
Re: Rear ride height question.
Buy new bolts,loosening the nut lowers the car.
|
|
|
|
|
06-01-2020
|
#3 |
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
Re: Rear ride height question.
Just hit the hardware store and buy new G-8 bolts that are longer with Lock nuts and youre golden...
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
|
|
06-05-2020
|
#4 | |
|
Join Date: Oct 2016
Location: Shepparton. Vic. Australia
Posts: 135
|
Re: Rear ride height question.
Quote:
Cheers from🇦🇺 |
|
|
|
|
|
06-05-2020
|
#5 |
 
Join Date: Apr 2007
Location: Northern VA
Posts: 2,644
|
Re: Rear ride height question.
Just installed SuperPro bushings on my 94. Ride and handling are much improved. You will be impressed.
Sent from my iPhone using ZR-1 Net Registry
__________________
Phil Wasinger 1994 Torch Red ZR-1 WAZOO Member George Braml Intake |
|
|
|
 |
|
|
Linear Mode
