|
12-21-2019
|
#11 |
 
Join Date: Apr 2007
Location: Northern VA
Posts: 2,644
|
Re: Gauging Interest - Reproducing License Plate Bracket
I would need to make at least 10 of these to justify the effort to make the mold tooling.
Sent from my iPhone using ZR-1 Net Registry
__________________
Phil Wasinger 1994 Torch Red ZR-1 WAZOO Member George Braml Intake |
|
|
|
12-23-2019
|
#12 |
 Join Date: May 2016
Location: Hawaii
Posts: 124
|
Re: Gauging Interest - Reproducing License Plate Bracket
Sign me up for one!
|
|
|
|
12-23-2019
|
#13 |
Join Date: Nov 2016
Location: Norway
Posts: 397
|
Re: Gauging Interest - Reproducing License Plate Bracket
I'd be surprised if you'd struggle getting rid of 10 pieces. Everywhere I've requested these, I've been told they are in high demand these days, and very hard to come by. I stille haven't found a single one.
__________________
- '90 ZR-1 |
|
|
|
|
12-23-2019
|
#14 |
|
Join Date: Apr 2007
Location: Northern VA
Posts: 2,644
|
Re: Gauging Interest - Reproducing License Plate Bracket
OK guys
I will proceed with the project It’ll be a few weeks to produce the molds. It takes two of them. Sent from my iPhone using ZR-1 Net Registry
__________________
Phil Wasinger 1994 Torch Red ZR-1 WAZOO Member George Braml Intake |
|
|
|
|
04-07-2020
|
#15 |
|
Join Date: Nov 2016
Location: Saudi Arabia
Posts: 1
|
Re: Gauging Interest - Reproducing License Plate Bracket
This is the rear plate I requested earlier? If so, I'm in for one.
|
|
|
|
 |
|
|
Linear Mode
