Re: Warped Injector Housings
 

Well I measured a gap of .022....looks like they were milled .025.....will see what the plenum fit is like

Re: Warped Injector Housings
 

.016 gap in the inside of one side of the plenum to IH....I think I can live with that and a.060 gasket. Thoughts?

Re: Warped Injector Housings
 

Depends where the distortion is. These things are somewhat prone to oil weapage of the PCV vent passages as the gasket tends to saturate in time and squeeze out the edge.

Re: Warped Injector Housings
 

Plenum to IH...the IH were machined top and bottom....no PCV issues with the plenum to IH....that's the IH to the head.

I would think with .016 gap......and a.060 gasket....I would have enough gasket crush to seal.

Re: Warped Injector Housings
 

ahh- I missed that detail... if it won't leak air or water, why not?

Re: Warped Injector Housings
 

Ugly day, putting the 90 back together...used 2 gaskets between the plenum and the IH. Everything went well but the first two bolts were off by about .5mm, maybe alittle less. had to grid the bolt hole to get the plenum on.

Not to sure this is going to work

Re: Warped Injector Housings
 

Its up and running, 900rpm idle...