Re: Traveling ZR-1 New Owner could use some help
 

I was wondering if you guys could give me some dimensions. I am going to put the emblems back on the freashly painted 91 ZR1 and I was wondering if you guys could give me some measurements on the proper location of the side and rear ZR1 emblems. Also is the 1990 zr1 bumper the same as the 91 except for the moldings? It looks like tshe is going to make it to the Vettes on Lex event.

Dave

Re: Traveling ZR-1 New Owner could use some help
 

I would think the rear emblem would go in holes in the bumper. Look at some pics of 92-95's and then just wing it as far as placement goes. I used 3M weatherstrip adhesive to put those on and it worked really well holding them.

Re: Traveling ZR-1 New Owner could use some help
 

91s did not have side emblems from the factory. Folks added them according to the placement on the 95s (and 94s?).

The rear emblem is 12" right of the LP opening and 1/2" below the molding. I don't think there were any factory holes for the emblem - the replacement ones I have are flat and attached with double-sided tape or trim cement.

When is the Vettes on the Lex thing happening and what club is coordinating?

Re: Traveling ZR-1 New Owner could use some help
 

I know I'm late on posting pics of the trip but here is a few that you guys may like. It was a good trip 7 weeks total, 10740 miles, 29 or 32 states, 55 museums,the oskosha airshow for a week and miles of memories.

Re: Traveling ZR-1 New Owner could use some help
 

Here is some more

Re: Traveling ZR-1 New Owner could use some help
 

And more

Re: Traveling ZR-1 New Owner could use some help
 

More

Re: Traveling ZR-1 New Owner could use some help
 

The Gilmore museum is pretty cool! Looks like a fun trip :thumbsup: