ZR-1 Net Registry Forums - Intake Torx Bolts size?

ZR-1 Net Registry Forums (http://zr1.net/forum/index.php)

- C4 ZR-1 General Postings (http://zr1.net/forum/forumdisplay.php?f=14)

- - Intake Torx Bolts size? (http://zr1.net/forum/showthread.php?t=14525)

Intake Torx Bolts size?

I tried to search for this question but can't find the true answer..

I ran into the snap-on guy this week and told him I needed and extra long T-size 3/8 ratchet extension to pull the intake on the Z if I needed to again but went blank when I was asking for the correct T-size.

So the question is what is the correct torx size of the bolts for the intake bolts? T-40 or T-45??

Re: Intake Torx Bolts size?

Quote:

Originally Posted by TFENT (Post 113475)

It should be a T-40 if we are talking about the bolt, plenum to injector housing.

http://jerrysgaskets.com/store2/root...roducts_id=406

Download this source from one of the greatest contributors to the ZR-1 and you will be all set for most of these questions. I could not have built my motor on my own without it.

:USFlag:

Aloha from Japan,

Craig