ZR-1 Net Registry Forums - Thinking of making some Aluminum pulleys

ZR-1 Net Registry Forums (http://zr1.net/forum/index.php)

- C4 ZR-1 General Postings (http://zr1.net/forum/forumdisplay.php?f=14)

- - Thinking of making some Aluminum pulleys (http://zr1.net/forum/showthread.php?t=14760)

Topfuel

05-23-2011 08:25 PM

Thinking of making some Aluminum pulleys

As the title says I am thinking of making 10 sets of aluminum billet pulleys. What I am thinking of making are: water pump , alt, If possible Power steering pulleys. Machined finish you can polish if you want then. Not sure what a set will cost or sell for but just seeing if there is any interest. Maybe the belt tentioner pulley also as an add on. :dancing
Question should I speed up or slow down the water pump pulley? If so how much % wise. :dancing
Thanks,Mike

LGAFF

05-23-2011 08:48 PM

Re: Thinking of making some Aluminum pulleys

How about an Under Drive for the ATI?

LGAFF

05-24-2011 05:51 PM

Re: Thinking of making some Aluminum pulleys

I think you would want to slow it down due to cavitation at higher RPM, undrive I believe solves that issue

All times are GMT -4. The time now is 08:55 AM.