ZR-1 Net Registry Forums

ZR-1 Net Registry Forums (http://zr1.net/forum/index.php)
-   C4 ZR-1 General Postings (http://zr1.net/forum/forumdisplay.php?f=14)
-   -   Proud new owner (http://zr1.net/forum/showthread.php?t=1741)

KOTH 05-01-2006 09:02 PM

Proud new owner
 
New owner with all the same questions.

I finally got my beast 3 weeks ago. All I can say is WOW, what an automobile.
Color is white with red interior as was the original. IThe automobile has flowmasters, not my choice but livable for now, 4:10 gear set, drmp chip, and short throw shift kit.

Trying to save some time and I was hoping to get a response as to all the potential items to look for: Quirks, trouble areas, common problems etc. Thank you in advance.

Anyone have a location of a reputable Dyno near NorthEast PA?
Best intake duct? Tell tale signs of collapsing duct when WOT?

This web site is great, very informative and enjoyable.

Keep the rubber side down,
Chris

We Gone 05-02-2006 07:38 AM

Re: Proud new owner
 
Welcome..:hello: And congrats on the ZR-1..=D>

tomtom72 05-02-2006 07:49 AM

Re: Proud new owner
 
:hello: Chris, congrats on your new toy! Yea, these cars can cure a bad day!
White over red must look sweet!=D>

You can find alot of stuff over at the NetRegistry site in the maintanence section, just click on the "maintanence" tab and there is a bunch of useful info.

Enjoy the new toy!:thumbsup:

ZR-1 Mack 05-02-2006 08:15 PM

Re: Proud new owner
 
Chris,

Congrats... The ZR-1 is an awesome car. Still puts a smile on my face every time I get behind the wheel.

Here's a link for air duct supports that Mark Haibeck sells and a photo of a collapsed duct.

Can't tell you how well they work but I would definitely check out his website when you have a few minutes. I'm sure there are other similar products out there that forum members can tell you about also.

Good luck:cheers:

Ron M.


http://www.zr1specialist.com/HAT%20W...ucts/hoops.htm

Z Factor 05-03-2006 12:28 PM

Re: Proud new owner
 
Quote:

Originally Posted by KOTH
New owner with all the same questions.

Trying to save some time and I was hoping to get a response as to all the potential items to look for: Quirks, trouble areas, common problems etc. Thank you in advance.

Best intake duct? Tell tale signs of collapsing duct when WOT?

This web site is great, very informative and enjoyable.

Keep the rubber side down,
Chris

Hello, and welcome to the forum Chris.:handshak:


You will find a wealth a information here by just looking through threads, doing searches etc. You will also get plenty of advice/help with specific questions you might have. Additionally here are some links to our main webpage that will answer many questions and cover things you have not even thought about yet.

http://www.zr1netregistry.com/ZR1_tech_tips.htm

http://www.zr1netregistry.com/ZR1_howto.htm

http://www.zr1netregistry.com/ZR1_issues.htm

http://www.zr1netregistry.com/ZR1_troubleshooting.htm

http://www.zr1netregistry.com/ZR1_techtips.htm

As to your duct, you have several choices. You can replace it with OEM, buy a support for it as suggested, or buy a Samco Air Duct. We had a group buy a little while back (link below) and you can still order one, but be warned it can take a long time before you receive it.

http://zr1netregistry.com/forum/showthread.php?t=833

When you get the chance, feel free to post some pictures of your White KOTH.:thumbsup:

:cheers:

95ZR1#418 05-03-2006 11:37 PM

Re: Proud new owner
 
:handshak:

Welcome Chris,

I think your questions have been answered with all the links available.:mrgreen:

I went with the K&N open lid for air. As far as the duct: Go to a Hardware store & buy 1 piece of aluminum (5 or 6" diameter-don't remember for sure, just measure it-you can figure it out) venting pipe(snaps together). squish it to a oval which fits inside the duct and pop rivit it in 2-3 places. Make it just short enough to allow the original plastic duct flanges to seal to the "horn" and filter assembly. This works better than anything else & you can't do it cheaper (~$3-5), also gives a smooth inner flow surface for air current.:wink:

It's easy to get into the habit of too much preventive maintenance, I'd say if it ain't broke don't fix it. Chance all your fluids, that will keep you busy putsing with it. You could always change hoses too considering the age of the cars now but this is a big job-I just did it. Save every part you replace.:wink:

Be sure to have the factory service manual. You'll get better replies/answers when people on the Net know you've made an honest attempt to diagnose the problem and have the instructions to perform whats needed. Sometimes they will just refer you to the page that you need to fix the problem.:mrgreen:

RedZR 05-07-2006 10:42 PM

Re: Proud new owner
 
Chris,

How far are you away from Moscow, Pa?
I have a pal who is a dentist in that area and owns a black/black 90 ZR1. He can steer you to some HPDE at Pocono.

Dan

KOTH 05-08-2006 06:19 AM

Re: Proud new owner
 
Thanks for all the replies. Alot of good information here.
RedZR I am 25minutes south of Moscow, PA would like to talk to your friend about Pocono events etc.

Can anyone recommend a service technician around the North east PA area?


All times are GMT -4. The time now is 05:54 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2025