LSx Coil Conversion
 

If only Lingenfelter would do the same for us. Take the 9 slot crank signal and convert it to 24 or 58x to run LS coils. Or even if we needed a crank wheel and then integrate to ECM bypassing the need for IM.

http://www.lingenfelter.com/sites/li...ule%20v1.5.pdf

Re: LSx Coil Conversion
 

maybe there would be too much interpolation with rapid engine speed changes trying to have an accurate crank angle signal with 9x to 58x.

Re: LSx Coil Conversion
 

Mike,

U could do 9x - 24x instead. BTW, you can avoid the interpolation by using a crank trigger on the balancer instead bypassing the stock reluctor. Perhaps ATI would modify an LT-5 balancer with 24 grooves for timing.

Re: LSx Coil Conversion
 

The new Raptor ECM for the LT5 will have LSx CnP capabilities... I hope to have them by November.

Cheers,
Ron

Re: LSx Coil Conversion
 

will it work nice with the CCM?

Re: LSx Coil Conversion
 

Ron,

I'll be anxious to see the capabilities and the cost. Keep me posted.

Re: LSx Coil Conversion
 

The Mega Squirt guys say they can make it work with our CCM. They seem to think it's no big deal. I guess we'll know for sure by the end of Sep when testing begins.