Electrical connector question
 

http://i658.photobucket.com/albums/u...pslhy2bzen.jpg

This is one of two connectors for the HVAC fan speed controller (fan resistor). Has anyone been successful in removing pins out of the plastic connector? Hold down clip is broken off and I found a replacement connector but if possible I would prefer to relocate existing pins as opposed to splicing the wires.

Re: Electrical connector question
 

That's a Metri-Pack 480 and here's enough information to get you through un-pining it. You don't need a specific release tool, just something that's very similar. Your connector should be 3 populated and 1 plugged I'm quite sure.

http://catalog.delphi.com/connectors...ure/met480.pdf

Cross-Sectional view is a "tell-all".

If you've bought a 4 pin connector and would like a correct cavity plug let me know.

Re: Electrical connector question
 

Hey Dave,

Thanks. Just what I needed. I bought a used controller and it's being sold with both connectors with cut wires.

Re: Electrical connector question
 

Thank you David. Successfully repinned.

Re: Electrical connector question
 

Good to hear all went well. See you "next month"!