ZR-1 Net Registry Forums - View Single Post

ittlfly · 03-01-2011

That's the one! I have the 8mm bolt out and the shield is off. I'm just not to sure on what to do here as it really is in there and I don't want to break something on the sensor yanking on it by the wires. I tried using a little leverage by putting back the the bolt back into the senosr and prying on it against the block. The sensor didn't budge. Thoughts?

BTW...it is the Cam sensor...the crank sensor is on the pass side...

03-01-2011	#3
ittlfly Join Date: Jul 2009 Location: Redding Calif Posts: 223	Re: Cam Positioning Sensor Removal That's the one! I have the 8mm bolt out and the shield is off. I'm just not to sure on what to do here as it really is in there and I don't want to break something on the sensor yanking on it by the wires. I tried using a little leverage by putting back the the bolt back into the senosr and prying on it against the block. The sensor didn't budge. Thoughts? BTW...it is the Cam sensor...the crank sensor is on the pass side...