ZR-1 Net Registry Forums - View Single Post

tccrab · 04-18-2011

Loosen the C-Beam bolts at the transmission and use a 2x4 to lever the transmission tail.
From "The ZF Doc's" website:

ALIGN DRIVELINE COMPONENTS: Take the following measurements directly above and to the right of the Propeller shaft front yolk universal joint. To ensure proper alignment of the driveline, a clearance of 45 mm +/- 6mm (1.77 in. +/- 0.236 in.) must be maintained between the top of the support to the underbody and a clearance of 28 mm+/-6 mm (1.1 in. +/- 0.236 in.) from the right side (passenger side of vehicle) of the support to the side wall.

Good luck!

TomC
'Crabs

04-18-2011	#13
tccrab Join Date: Oct 2004 Location: Folsom CA Posts: 1,663	Re: My car update Loosen the C-Beam bolts at the transmission and use a 2x4 to lever the transmission tail. From "The ZF Doc's" website: ALIGN DRIVELINE COMPONENTS: Take the following measurements directly above and to the right of the Propeller shaft front yolk universal joint. To ensure proper alignment of the driveline, a clearance of 45 mm +/- 6mm (1.77 in. +/- 0.236 in.) must be maintained between the top of the support to the underbody and a clearance of 28 mm+/-6 mm (1.1 in. +/- 0.236 in.) from the right side (passenger side of vehicle) of the support to the side wall. Good luck! TomC 'Crabs