ZR-1 Net Registry Forums - View Single Post

902066 · 05-19-2011

I have pulled the center section and batwing of my rear end for a gear swap. I have a Quik Lift which is ideal for this job. Held the back of the tranny up with the Quik lift bridge and a small bottle jack, lowered the rear center section and batwing with the floor jack. If your not taking out the 1/2 shafts and knuckles it's pretty easy. Undoing u-joints and pulling drive shaft is easy, hardest part is wrestling with the support beam.

05-19-2011	#3
902066 Join Date: Jul 2005 Posts: 190	Re: Removing rear end for upgrade I have pulled the center section and batwing of my rear end for a gear swap. I have a Quik Lift which is ideal for this job. Held the back of the tranny up with the Quik lift bridge and a small bottle jack, lowered the rear center section and batwing with the floor jack. If your not taking out the 1/2 shafts and knuckles it's pretty easy. Undoing u-joints and pulling drive shaft is easy, hardest part is wrestling with the support beam.