ZR-1 Net Registry Forums - View Single Post

mike100 · 06-14-2011

Additionally:

How much rpm/ piston speed is too much for the LT5? If you stretched the old rod bolts at all, do the rods need to be re-sized? If they are already egg shaped, the new bolts might not help.

Then again, if you didn't have a lower end failure when the engine came out, everything may still be ok.

06-14-2011	#5
mike100 Join Date: Feb 2011 Location: San Marcos CA Posts: 1,786	Re: Rod Bolts Additionally: How much rpm/ piston speed is too much for the LT5? If you stretched the old rod bolts at all, do the rods need to be re-sized? If they are already egg shaped, the new bolts might not help. Then again, if you didn't have a lower end failure when the engine came out, everything may still be ok.