Quote:
Originally Posted by Socalerv
I just bought a 90ZR1 with 19438 miles and have a few questions.
|
Nice, what colors, any mods at all, last 4 of the VIN? Any pics available? Everyone will agree that we like pics. Welcome to the brotherhood.
Quote:
Originally Posted by Socalerv
1. Need a good shop manual
|
As mentioned, used ones (and new ones) come up on Ebay. You can also go to
http://www.helminc.com/helm/product2...T5K&itemtype=K
Quote:
Originally Posted by Socalerv
2. Need good advice in cleaning engine
|
I know it goes against what others have said, but I have had great luck using Gunk on the motor. Stand by with water and rags. A pressure washer has worked well and I have even done this at a car wash several times. I spray the Gunk on liberally, let it soak for just a couple minutes and then spray it off, keeping it away from openings that will lead to the engine valley as much as possible. I wipe the motor down quickly and start it right away. Never had a problem. You might check the drain, a little tube by the lower bellhousing area, blow air, or run a coat hanger up through it to make sure it's clear. (Do this anyway)
Quote:
Originally Posted by Socalerv
3. Need a good shop in the Houston, Texas area
|
Concur, Corey is the "man" in your area, wish he was a close to me as to you. I rode in a 415 ci he built, WOW.
Quote:
Originally Posted by Socalerv
4. RPM for idle
|
Concur, stock chip in 90-91 caused high idle.
Quote:
Originally Posted by Socalerv
5. Need advice in cleaning leather seats
|
I use Adams cleaner and then conditioner.
Quote:
Originally Posted by Socalerv
I have a 69 and can turn a wrench but this is all new to me. Help is very much appreciated.
|
Pics of your '69 would be nice too.
Hope my comments help, others have/will post up.