ZR-1 Net Registry Forums - View Single Post

BlackbirdZ07 · 05-15-2012

Well, I got the codes cleared. I don't know exactly what worked, but I kept doing different things (including the procedure above) and I finally figured out that I had cleared all the codes except one: code 14, which is the right front. I think the codes were cleared but then 14 reset every time I turned the ignition on.

So I removed the actuator... shock gear and actuator looked fine, but actuator did not move when I turned the key on. Bad actuator?? To test that, I removed the actuator, disconnected the left front actuator and plugged the suspect actuator into the left front connector. Low and behold, it moved when I turned on the key... so the actuator is NOT bad. It's not getting power for some reason. Any ideas?

05-15-2012	#7
BlackbirdZ07 Join Date: Feb 2012 Location: Albuquerque, NM Posts: 34	Re: How to clear FX3 codes? Well, I got the codes cleared. I don't know exactly what worked, but I kept doing different things (including the procedure above) and I finally figured out that I had cleared all the codes except one: code 14, which is the right front. I think the codes were cleared but then 14 reset every time I turned the ignition on. So I removed the actuator... shock gear and actuator looked fine, but actuator did not move when I turned the key on. Bad actuator?? To test that, I removed the actuator, disconnected the left front actuator and plugged the suspect actuator into the left front connector. Low and behold, it moved when I turned on the key... so the actuator is NOT bad. It's not getting power for some reason. Any ideas?