Quote:
Originally Posted by ghlkal
**update** OK, I got it ... my problem was I was trying to remove the circuit board without removing the white "intermediate" piece between the gauge faces and the circuit board. Once that was off, it was "easy" to pop the LCD connectors (I'll add more later)
Doh ... thanks Paul! (Yes, after looking at the white connector, it's soldered to the cluster, isn't it)
Now, I'm trying to carefully pry that reddish-brown plug from the LCD itself, but ... it's not obvious to me how do that. I'm using a plastic prybar (for dash pieces) and I can't seem to wedge it anywhere. If that's where it comes off, then I'll just try a little more force ...
|
I have a few hemostats in my "kit" which come in handy for things like extracting and inserting stuff in tight quarters; that connector for one.
Lucky I just happen to have an IP cluster board sitting on a table next to me when I read your post (doesn't everyone??
).
P.