ZR-1 Net Registry Forums - View Single Post

batchman · 10-11-2012

It took all summer but I finally have ready:
- 1000lb front spring
- 500lb rear spring
- 32mm hollow front bar
- revalved Penskes

While apart for above I'll be going out for Delrin LCA bushings.

On the fence whether I should bite the bullet and get the Guldstrand upper arms and do those at the same time.

Meanwhile hope to pull some weight out and maybe try the bias spring or just go to the Camaro master cylinder I picked up a while back.

And then there's re-doing the exhaust, pulling the plenum/secondaries/PCV setup etc.

Here's to next season (this year was a bust).
- Jeff

10-11-2012	#11
batchman Join Date: Jun 2009 Location: I live at Devens, one run at a time Posts: 454	Re: Who's Modding this winter? It took all summer but I finally have ready: - 1000lb front spring - 500lb rear spring - 32mm hollow front bar - revalved Penskes While apart for above I'll be going out for Delrin LCA bushings. On the fence whether I should bite the bullet and get the Guldstrand upper arms and do those at the same time. Meanwhile hope to pull some weight out and maybe try the bias spring or just go to the Camaro master cylinder I picked up a while back. And then there's re-doing the exhaust, pulling the plenum/secondaries/PCV setup etc. Here's to next season (this year was a bust). - Jeff