ZR-1 Net Registry Forums - View Single Post

mgg · 12-23-2012

HawaiiZR-1, Saw your post. I used a bi-metal hole saw that fit perfectly just inside Carters bracket. I remember last time doing this I used a dremel tool and it took forever. With the bi-metal hole saw and an 18 volt drill it took about a minute. I could not believe it. Sure made the job easier and a nice cut as well. Good luck.

12-23-2012	#104
mgg Join Date: Aug 2009 Location: Hamilton, Va. Posts: 113	Re: GB: DRM Coilovers HawaiiZR-1, Saw your post. I used a bi-metal hole saw that fit perfectly just inside Carters bracket. I remember last time doing this I used a dremel tool and it took forever. With the bi-metal hole saw and an 18 volt drill it took about a minute. I could not believe it. Sure made the job easier and a nice cut as well. Good luck.