ZR-1 Net Registry Forums - View Single Post

rkreigh · 01-24-2013

a couple of recommendations for you

even though it's super convenient to use that port on the throttle body I'd move it to the bottom and center it so the fan sprays straight down the throat and gives a better mixture/distribution. I'd use a silicone samco duct and just cut right in the center more towards the air filter to give the alchy the best suspension and more time to make the turns into the ports.

your way will probably work just fine, but I'm a purist and want to get the mixture as even as possible on all 8 cyl.

it might be overkill but I always worry about puddling injecting at a 90 deg angle to the airflow

also, spray pure meth. it will give you all the cooling you need and burn it all for more power. the water/meth mix will work well too but I think you'll be happier on pure alchy

good luck, great project.

01-24-2013	#52
rkreigh Join Date: Jan 2004 Location: Alex VA Posts: 1,080	Re: Water/Methanol Injection... a couple of recommendations for you even though it's super convenient to use that port on the throttle body I'd move it to the bottom and center it so the fan sprays straight down the throat and gives a better mixture/distribution. I'd use a silicone samco duct and just cut right in the center more towards the air filter to give the alchy the best suspension and more time to make the turns into the ports. your way will probably work just fine, but I'm a purist and want to get the mixture as even as possible on all 8 cyl. it might be overkill but I always worry about puddling injecting at a 90 deg angle to the airflow also, spray pure meth. it will give you all the cooling you need and burn it all for more power. the water/meth mix will work well too but I think you'll be happier on pure alchy good luck, great project.