View Single Post
Old 03-28-2013   #75
mgbrv8
 
Join Date: Jul 2009
Location: Texas
Posts: 790
Default Re: Plenum pull advice

Well My r12 oil came in today so I was able to crack open the compressor. Now a point I need to make is that all components when I removed I washed in hot water and Dawn soap And then dried thoroughly with a rag and compressed air I washed everything except for the piston and cylinder Assembly. I cleaned all of the Mating surfaces and vave plates And put a light film of r12 oil on everything after cleaning. I then assembled all the components once cleaned and installed the bolts only tightening them finger tight. When the bolts began to bottom out I would move them clockwise counterclockwise to try to force as much oil out of the bottom of the threads as possible To avoid hydro-locking oil in the cavity causing a crack. Once the assembly was together I placed my thumb over the intake port and could feel a strong vacuum that was stronger than it was before disassembly.

David
Attached Images
File Type: jpg 100_0658.jpg (70.3 KB, 27 views)
File Type: jpg 100_0659.jpg (61.5 KB, 26 views)
File Type: jpg 100_0661.jpg (50.1 KB, 25 views)
File Type: jpg 100_0662.jpg (78.3 KB, 25 views)
File Type: jpg 100_0664.jpg (71.8 KB, 26 views)

Last edited by mgbrv8; 03-28-2013 at 08:30 PM.
mgbrv8 is offline   Reply With Quote