ZR-1 Net Registry Forums - View Single Post - TPS re-install boo-boo (snappics); HELP???

Schrade · 07-26-2013

Further investigation, by rolling the butterfly shaft of the TB through the range of motion, with the backprobes still in place, shows a STEADY voltage increase, with a reading at about halfway, of 2.52V.

This seems to indicate that the computer is indeed accounting for the non-linear increase in resistance, of the TPS's potentiometer.

This still does not account for the 'off-idle sag'.

Anyone with thoughts here?

07-26-2013	#6
Schrade Join Date: Dec 2012 Location: NC Posts: 1,783	Re: TPS re-install boo-boo (snappics); HELP??? Further investigation, by rolling the butterfly shaft of the TB through the range of motion, with the backprobes still in place, shows a STEADY voltage increase, with a reading at about halfway, of 2.52V. This seems to indicate that the computer is indeed accounting for the non-linear increase in resistance, of the TPS's potentiometer. This still does not account for the 'off-idle sag'. Anyone with thoughts here?