ZR-1 Net Registry Forums - View Single Post

ALZR1 · 09-14-2013

[QUOTE=Polo-1;182755]Hey Al

It was both that Greg had mill flat.
I bought all new plenum, and housings, sent out for siamese runners got back a wrapped used mess from Kirchhofer. I sat on it for a few years then had Greg Van Deventer port it and mill it all flat. So I bought new parts, got used parts back that would not seal, then Had the right Guy fix it.... This is why I say " go to the right guy first ".

[/QUOTE.

Typical of him to pull shiit like that,I know exactly how you feel.

AL.

09-14-2013	#2
ALZR1 Join Date: Nov 2007 Location: chicago Posts: 200	Re: If/When you go to siamesed Intakes? [QUOTE=Polo-1;182755]Hey Al It was both that Greg had mill flat. I bought all new plenum, and housings, sent out for siamese runners got back a wrapped used mess from Kirchhofer. I sat on it for a few years then had Greg Van Deventer port it and mill it all flat. So I bought new parts, got used parts back that would not seal, then Had the right Guy fix it.... This is why I say " go to the right guy first ". [/QUOTE. Typical of him to pull shiit like that,I know exactly how you feel. AL.