View Single Post
Old 12-03-2013   #346
Schrade
 
Join Date: Dec 2012
Location: NC
Posts: 1,783
Default Re: TOP END REFINISHING

The 'Ticket Stopper' dropped my rpm's to 475, STEADY. although rough, like a cammed motor.

Looks like I blew the TB re-assembly. I could NOT see light through the secondaries, but, the Ticket Stopper doesn't lie.

I'll cut out the IAC opening, and see how that effects idle, before shipping the TB off to Marc for a re-work.

Thanks again there Dom, for the phone time there - LOOKS like this thread is about ready to close.............


ed.:
Just saw your post here Jerry; got it. Should I leave the IAC port blocked as well, before doing your test? She would barely run as it was, and actually DID cut off after about 7-8 minutes, while on the phone with Dominic there...

Last edited by Schrade; 12-03-2013 at 05:12 PM.
Schrade is offline   Reply With Quote